Dashboard for Industrial Load Control and Remote Power Factor Correction Based on Adafruit's MQTT

Irgi  Surya; Jaja  Kustija

doi:10.12928/biste.v5i1.7494

Authors

Irgi Surya Universitas Pendidikan Indonesia
Jaja Kustija Universitas Pendidikan Indonesia

DOI:

https://doi.org/10.12928/biste.v5i1.7494

Keywords:

MQTT, Adafruit, Monitoring, Electrical Loads, Internet of Things

Abstract

One of the user interface problems in an internet of things (IoT) system is influenced by monitoring which is easy to access, flexible and efficient in its use, has been discussed a lot but the problem is still unresolved, one solution to this problem is by presenting the Adafruit mqtt, which by using the mqtt Adafruit user interface for monitoring on an internet of things system can facilitate control and remote control. In this case the use of Adafruit mqtt is used to monitor electrical loads and improve power factor. This research presents an internet of things system that is capable of monitoring electrical load and improving power factor that already uses the Adafruit mqtt as its user interface. The method used is through the Analysis, Design, Development, Implementation, Evaluation (ADDIE) approach. The results showed that this system is feasible to use because based on the experimental results this system is able to work well and provide convenience for users and can monitor in real time current, voltage, energy, frequency, power factor, real power, apparent power, and reactive power. only by using smartphones, laptops, tablets, or computers. It is hoped that in the future this research will be able to continue to be developed so that the use of electrical energy in industry can be much more effective and efficient.

References

J. Kustija, K. S. Nur Adillawati, and D. Fauziah, “Smart home system to support Bandung smart city programme,” Pertanika J. Sci. Technol., vol. 25, no. S, pp. 77–88, 2017, http://www.pertanika.upm.edu.my/pjst/browse/special-issue?article=JST-S0318-2017.

M. A. Rahman, Y. Li, T. Nabeed and M. T. Rahman, "Remote monitoring of heart rate and ECG signal using ESP32," 2021 4th International Conference on Advanced Electronic Materials, Computers and Software Engineering (AEMCSE), pp. 604-610, 2021, https://doi.org/10.1109/AEMCSE51986.2021.00127.

J. Kustija and N. Dwi Jayanto, “IoT Implementation for Development of Remote Laboratory (Case Study on Microscope Practice),” Reka Elkomika, vol. 3, no. 1, pp. 20–29, 2022, https://doi.org/10.26760/rekaelkomika.v3i1.20-29.

J. Kustija and Purnawan, “Solutions To Overcome Inequality in Laboratory Facilities and Laboratory Sharing in Similar Institutions Remote Laboratory Based,” Journal of Engineering Science and Technology (JESTEC), vol. 17, no. 3, pp. 1792–1809, 2022, https://jestec.taylors.edu.my/Vol%2017%20Issue%203%20June%202022/17_3_13.pdf.

J. Kustija and F. Andika, “Control - Monitoring System Of Oxygen Level, Ph, Temperature And Feeding in Pond Based on Iot,” REKA ELKOMIKA J. Pengabdi. Kpd. Masy., vol. 2, no. 1, pp. 1–10, 2021, https://doi.org/10.26760/rekaelkomika.v2i1.1-10.

T. Vince et al., “IoT implementation in remote measuring laboratory VMLab analyses,” Journal of Universal Computer Science, vol. 26, no. 11, pp. 1402–1421, 2020, https://doi.org/10.3897/jucs.2020.074.

N. D. Jayanto and J. Kustija, “Remote desktop system in IoT and HTML 5-based virtual laboratory for HMI (Human Machine Interface) practicum and hydraulic simulation,” IOP Conference Series: Materials Science and Engineering, vol. 830, no. 4, 2020, https://doi.org/10.1088/1757-899X/830/4/042052.

P. W. Rusimamto, E. Endryansyah, L. Anifah, R. Harimurti and Y. Anistyasari, “Implementation of arduino pro mini and ESP32 cam for temperature monitoring on automatic thermogun IoT-based,” Indones. J. Electr. Eng. Comput. Sci., vol. 23, no. 3, pp. 1366–1375, 2021, https://doi.org/10.11591/ijeecs.v23.i3.pp1366-1375.

J. Kustija, A. Ana and N. D. W. I. Jayanto, “Web-based and thinvnc remote laboratory implementation to support students skills in mechatronics course to face the industrial revolution 4.0,” Journal of Engineering Science and Technology (JESTEC), vol. 16, no. 2, pp. 1800–1813, 2021, https://jestec.taylors.edu.my/Vol%2016%20issue%202%20April%202021/16_2_63.pdf.

A. Sumardiono, S. Rahmat, E. Alimudin and N. A. Ilahi, “Sistem Kontrol-Monitoring Suhu dan Kadar Oksigen pada Kolam Budidaya Ikan Lele,” JTERA (Jurnal Teknologi Rekayasa), vol. 5, no. 2, p. 231, 2020, https://doi.org/10.31544/jtera.v5.i2.2020.231-236.

G. Ilieva, “IoT in Distance Learning during the COVID-19 Pandemic,” TEM Journal, vol. 9, no. 4, pp. 1669–1674, 2020, https://doi.org/10.18421/TEM94-45.

I. Surya and J. Kustija, “Implementation of the Electricity Load Monitoring Trainer and Internet of Things-based Power Factor Improvement,” International Journal of Scientific and Research Publications, vol. 12, no. 11, pp. 206–215, 2022, https://doi.org/10.29322/IJSRP.12.11.2022.p13127.

F. Jonathan and T. W. O. Putri, "Prototype of Home Power Monitoring Tool for Electrical Outlet Using ESP32," 2021 International Conference on ICT for Smart Society (ICISS), pp. 1-5, 2021, https://doi.org/10.1109/ICISS53185.2021.9533189.

Z. Chen, R. Khemmar, B. Decoux, A. Atahouet and J. -Y. Ertaud, "Real Time Object Detection, Tracking, and Distance and Motion Estimation based on Deep Learning: Application to Smart Mobility," 2019 Eighth International Conference on Emerging Security Technologies (EST), pp. 1-6, 2019, https://doi.org/10.1109/EST.2019.8806222.

S. Anand and V. Nath, “Study and design of smart embedded system for remote health monitoring using internet of things,” Lecture Notes in Electrical Engineering, vol. 511. pp. 409–414, 2019, https://doi.org/10.1007/978-981-13-0776-8_37.

A. Škraba, A. Koložvari, D. Kofjač, R. Stojanović, E. Semenkin and V. Stanovov, "Prototype of Group Heart Rate Monitoring with ESP32," 2019 8th Mediterranean Conference on Embedded Computing (MECO), pp. 1-4, 2019, https://doi.org/10.1109/MECO.2019.8760150.

N. A. Afifie et al., “Evaluation Method of Mesh Protocol over ESP32 and ESP8266,” Baghdad Science Journal, vol. 18, no. 4, pp. 1397–1405, 2021, https://doi.org/10.21123/bsj.2021.18.4(Suppl.).1397.

P. Megantoro, S. A. Aldhama, G. S. Prihandana, P. Vigneshwaran, “IoT-based weather station with air quality measurement using ESP32 for environmental aerial condition study,” Telkomnika (Telecommunication, Computing, Electronics and Control), vol. 19, no. 4, pp. 1316–1325, 2021, https://doi.org/10.12928/telkomnika.v19i4.18990.

N. Nikolov and O. Nakov, "Research of Secure Communication of Esp32 IoT Embedded System to.NET Core Cloud Structure using MQTTS SSL/TLS," 2019 IEEE XXVIII International Scientific Conference Electronics (ET), pp. 1-4, 2019, https://doi.org/10.1109/ET.2019.8878636.

Y. H. Lin, “Novel smart home system architecture facilitated with distributed and embedded flexible edge analytics in demand-side management,” Int. Trans. Electr. Energy Syst., vol. 29, no. 6, 2019, https://doi.org/10.1002/2050-7038.12014.

J. Kustija, I. Surya and D. Fahrizal, “Design of automated power factor monitoring and repair tool for industry in real time based on Internet of Things,” International Journal of Science and Technology Research Archive, vol. 3, no. 2, pp. 1–8, 2022, https://doi.org/10.53771/ijstra.2022.3.2.0106.

R. B. Salikhov, V K. Abdrakhmanov and I. N. Safargalin, “Internet of things (IoT) security alarms on ESP32-CAM,” Journal of Physics: Conference Series, vol. 2096, no. 1, 2021, https://doi.org/10.1088/1742-6596/2096/1/012109.

N. Fujii and N. Koike, "IoT Remote Group Experiments in the Cyber Laboratory: A FPGA-based Remote Laboratory in the Hybrid Cloud," 2017 International Conference on Cyberworlds (CW), pp. 162-165, 2017, https://doi.org/10.1109/CW.2017.29.

M. Babiuch and P. FoltÝnek, "Creating a Mobile Application with the ESP32 Azure IoT Development Board Using a Cloud Platform," 2021 22nd International Carpathian Control Conference (ICCC), pp. 1-4, 2021, https://doi.org/10.1109/ICCC51557.2021.9454607.

S. Nikolic, M. Ros, K. Jovanovic and Z. Stanisavljevic, “Remote, simulation or traditional engineering teaching laboratory: a systematic literature review of assessment implementations to measure student achievement or learning,” European Journal of Engineering Education, vol. 46, no. 6. pp. 1141–1162, 2021, https://doi.org/10.1080/03043797.2021.1990864.

V. Pravalika, “Internet of things based home monitoring and device control using Esp32,” International Journal of Recent Technology and Engineering (IJRTE), vol. 8, no. 1S4, pp. 58–62, 2019, https://www.ijrte.org/wp-content/uploads/papers/v8i1s4/A10110681S419.pdf.

A. Kumar and V. Nath, “Study and design of smart embedded system for smart city using internet of things,” Lecture Notes in Electrical Engineering, vol. 511. pp. 397–408, 2019, https://doi.org/10.1007/978-981-13-0776-8_36.

A. Kumar, N. N. Raju, P. Muthukumar and P. V. Selvan, “Experimental studies on industrial scale metal hydride based hydrogen storage system with embedded cooling tubes,” International Journal of Hydrogen Energy, vol. 44, no. 26, pp. 13549–13560, 2019, https://doi.org/10.1016/j.ijhydene.2019.03.180.

M. D. Tobi and V. N. V. Harling, “Prototype Design of Wireless Electric Energy Transmission System and Distance Electric Recording Record System Using PZEM004T and NRF24L01 Module,” Journal of Physics: Conference Series, vol. 1783, no. 1, 2021, https://doi.org/10.1088/1742-6596/1783/1/012074.

K. Chooruang and K. Meekul, "Design of an IoT Energy Monitoring System," 2018 16th International Conference on ICT and Knowledge Engineering (ICT&KE), pp. 1-4, 2018, https://doi.org/10.1109/ICTKE.2018.8612412.